Publicidad
Attach Wall Plate to Wall
STEP 2C
CAUTION
: Avoid potential personal injuries and property damage!
●
Studs must be at least 2 x4 in. / 25 ga.
●
If back side of wall is unfinished, drywall must be installed to a minimum of one stud left and right of the stud(s) being used to install the mount.
●
Drywall must be a minimum of 1/2 in. (13 mm) thick on each side of the studs, and a minimum clearance of 1 7/8 in. (48 mm) behind the wall is required.
●
This product must be centered on the studs.
●
Stud type and structural strength must conform to the North American Specification for the Design of Cold-Formed Steel Structural Members [362 S 125 18, C-Shape, S - Stud Section].
●
Drywall must be secured to studs with screws 12 in. (304.8 mm) on center.
1.
Locate the stud. Verify the center of the stud using an awl, a thin nail, or an edge to edge stud finder. Mark the center of the stud with a pencil.
2.
Place the wall plate
16
CAUTION:
Avoid potential personal injury or property damage! Do not use the three middle slots for mounting.
NOTE: For assistance in determining wall plate location, see Height Finder at sanus.com.
1
12
at your desired height and position over your stud center lines. Level the wall plate
Steel Stud Installation
*
Steel Stud Anchor Kit is NOT INCLUDED
1-800-359-5520 to have the additional hardware shipped directly to you.
2
16
Contact Customer Service at
and mark the hole locations.
16
Min.
16 in.
(406 mm)
Publicidad
