Timer Setting - TESY HPWH 2.1 200 U02 Manual De Usuario

In order to save energy, avoid setting the temperature above 55
pump will work without the help of the E-Heater!
5. Switching the unit OFF
To switch the unit OFF press
5. "Boost mode"
While the heat pump is running, press this button
and the electrical heater will work according to the control program together with the compressor until the set temperature is
reached.
FLEXIBLE USAGE OF YOUR APPLIANCE!

6. Timer setting

- After switching the appliance on, press and hold
and hour icon "88:" will flash together;
on icon
- Press the and buttons to set the exact hour(s).
button to transfer to minute setting, minute icon ":88" will flash, press the
- Press
minute(s).
- Press button again to transfer to timer off setting, the timer off icon
- Press the and buttons to set the exact hour(s).
button to transfer to minute setting, minute icon ":88" will flash, press the
- Press
minute(s).
- Press button again to save and exit the timer setting interface.
button to cancel the timer, while the "timer setting" mode is active!!!
Press
NOTE:
The timer 'ON' and timer 'OFF' functions can be set at the same time.
1)
2) The timer settings are repeating.
3) The timer settings are still valid after a sudden power cut.
button and hold it for 2 seconds while the unit is running. The display will look like:
,
URGENT NEED OF HOT WATER!
.
standby mode:
to turn 'ON' "Boost mode". The heater icon
button for 5 seconds to enter the timer setting interface, the timer
Page 5 of 71
o
C if not necessary! This way the heat
and buttons to set the exact
and hour icon "88:" will flash together.
and buttons to set the exact
will be shown,