PLYMOVENT MOBILEONE Instrucciones Para El Uso página 6

the mobile one
2. mount the flange(a) to the filter cabinet and the rubber collar (b)
on the inner arm.
then mount the arm on the filter.
note! place the Washer (e) betWeen flange and arm.
4. adjust all friction joints to correct tension.
051113/0 MobileOne
1. attach inner arm to outer arm by
means of hinged joint.
mounting instruction
kua-arm
© copyright 2008: all rights reserved. all information within this printed matter may not be reproduced,
handed over, copied, xeroxed or translated into another language in any form or means without written
permission from plymovent ab. plymovent ab reserves the right to make design changes.
3. fit hose, hose clip, hood collar and hood to
outer arm. (hose 400mm/16").
5. fit hoses and hose clamps (hose 650mm/25").
e
b
a
M1/5/14
EN - 5