Rupes LR21AE Instrucciones De Uso Y Manutención página 10

USABLE ABRASIVE PAPER DISCS
LR21AE
Ø 125 mm velcro abrasive paper discs with dust extraction holes.
LR31AE
Ø 150 mm velcro abrasive paper discs with dust extraction holes.
MAINTENANCE
All maintenance operations are carried out with the power
supply disconnected.
At the end of each work session, or when required, remove
any dust from the body of the tool using a jet of compressed
air, paying particular attention to the motor ventilation slots.
No other maintenance operations must be undertaken by
the user.
Maintenance and cleaning of the inner parts, like brushes, ball
bearings, gears etc. or others, must be carried out only by an
autorized customer-service workshop.
ELECTRIC SAFETY - LOW TENSION
The tests have been carried out in accordance with the stan-
dard:
EN 60745-1 safety of hand-held electric motor operated tools
EN 60745-2-4 particular requirements for sanders.
RADIO SUPPRESSION
The tools are suppressed in accordance for the prevention
and elimination of radio disturbances measured in accordance
with standard: EN55014-1+EN55014-2; EN61000-3-2+
EN61000-3-3.
NOISE LEVEL
The noise level produced is 75 dB (A), measured according to
regulation EN ISO 3744 + UNI EN ISO 11202.
Warning: wear suitable hearing protections! (see warnings).
10
MEAN ACCELERATION VALUE
The mean quadratic acceleration value is less than 2,5 m/sec
measured in accordance with standard UNI EN 28662 + UNI
EN ISO 5349.
GUARANTEE
All tools manufactured by RUPES Spa are guaranteed for 12
months from the date of purchase against fabrication and ma-
terial defects.
All tools must be used only with RUPES original accessories
and spare parts: we refuse all responsibility for damages or
accidents caused by non-observance of this rule which will al-
so cause the termination of the guarantee.
The guarantee will no longer be valid if the instructions contai-
ned in this booklet are not followed, if the tool is used for pur-
poses other than that for which it is intended, if it is disman-
tled, interfered with in any way or damaged due to neglect.
The guarantee will be made valid by filling-in the form on
the inside back cover of this instruction booklet.
If the tool is found to be defective or malfunctions, it should be
returned carriage free in one piece in its original packing to-
gether with the guarantee certificate to the manufacturer or to
one of the Assistance Centres listed in the appendix to this
booklet.
The guarantee does not automatically imply replacement of
the tool.
RUPES Spa reserves the right to make any technical or desi-
gn modification to its products without prior notice.
The manufacturer is not liable for any print errors. This docu-
ment voids and replaces previous ones.
2