Plumbing Diagrams - HACH LANGE APA 6000 Mantenimiento Y Solución De Problemas

Option Description
SENSOR Disable (off) or enable (on) warnings triggered by power
WARNING failures.
OPTIONS
DEFAULT Set the calibration to the factory default. A Default Cal
CALIBRATION warning is entered in the alarm/warning log. Default Cal
is not recorded in the calibration history.
Start a calibration after the calibration is set the factory
default.
SAMPLE Select the number of sample streams–1 (default) or 2.
STREAMS Use the optional sample sequencing kit to add a
second sample stream.
CLEAR ALARM Erase the alarms from the alarm/warning log and set
LOG point alarm log.
SHOW VERSION Show the firmware revision numbers for the main
NUMBERS EPROM, internal neuron and external neuron.
SIO1 (or SIO2) When an optional serial I/O module is installed, select
SETUP the serial I/O module output format (computer or
printer) for measurement readings, alarms and
warnings. A maximum of two serial I/O modules can be
used (SIO1 or SIO2). If PRINTER is selected for the
output format, the options that follow are not available.
AUTO—Readings, alarms and warnings are sent out to
the computer as they occur.
QUERIED—Readings, alarms and warnings are sent
out to the computer when an RS232 query command is
sent from the computer.
TIME/DATE OUTPUT—When Yes is selected, the time
and date are sent out with readings, alarms and
warnings.
Appendix

Plumbing diagrams

Figure 9–Figure 12 show the plumbing connections for the analyzers.
Figure 9 Plumbing diagram – Alkalinity analyzer
1 Mixing chamber 7 Colorimeter drain
2 Rotary valve 8 Cleaner
3 Colorimeter 9 Reagent 2
4 Reaction coil 10 Reagent 1
5 Auxiliary valve 11 Standard 2
6 Pump (autoburette) 12 Holding coil
13 Standard 1
14 Mixing chamber
drain
15 Waste
16 Sample 2
17 Sample 1
English 21