Yakima FrontLoader Manual Del Usuario página 2

Place FrontLoader onto crossbars.
Open the rear clamp.
It may be necessary to turn the t-bolt to allow
it to pass through the slot in the clamp.
Lower the front
clamp into place
over front crossbar.
Tighten clamps.
Tighten the front clamp.
Turn the knob clockwise to
completely tighten the front
clamp around crossbar.
Adjust clamp if necessary.
1033644D-2/18
Tighten the rear clamp.
Close rear clamp
around rear crossbar.
Turn the knob clockwise to completely tighten the rear clamp.
Upper notch for round
and square bars.
Open the front clamp. Turn the
front knob counter clockwise
to open the front the clamp.
Use caution to avoid damaging
roof's finish. A towel placed
on the roof prior to installation
can help avoid scratches.
Slide the jaw of the
rear clamp under
rear crossbar.
Pass the t-bolt through the opening in bail.
Rotate t-bolt to rest in slot in bail.
If you don't get a secure grip with
your factory bars adjust your clamp.
For factory bars
choose the best
position for most
secure grip.
90°