Suzuki 990D0-05H00-ALM Manual Del Usuario página 5

Two-sided adhesive tape is provided in the Kit and can be used to fix the LED's plastic support.
In this case, the tape must be cut to size and applied to the bottom of the LED without removing
Re-assemble the previously removed plastic parts on both sides of the scooter.
STEP-BY-STEP FITTING GUIDE - BURGMAN 400
The vehicle's original electrical system is pre-engineered for connecting the alarm system.
The two connectors (one-pole connector and four-pole connector, closed with counterpart)
Photo A: Clean the base of the alarm control unit and apply the larger piece of double-sided adhesive
tape supplied in the kit (1).
Connect the connector of the alarm wiring to the control unit, fit the rubber cap into the relative housing
and fix it in place with the plastic clamp (2). Turn the antenna and fix it into the slot in the control unit
(3) with the clamp.
Definition of the connectors; (4) Pre-engineering for the Alarm, (5) Turn indicators, (6) LED.
Adapt the alarm wiring to suit the dimensions shown in the picture (A). Use tape or a clamp to join the
two branches of the wiring to connector (4) and (5). The distance between connector (5) and connector
(4) must be 160 mm.
Photo 1: Remove the portion of fairing from above the headlight (A) by unscrewing the two screws near
the rear view mirrors and extracting the central pin from between the two headlights. Disassemble the
main fairing by unscrewing the screws from around the perimeter of the vehicle. Lift up the two foot mats
and remove the screws and plastic clips until you reach halfway along the central tunnel. There are other
screws and clips to remove in the internal front area alongside the radiator (B).
The central lower fairing must also be removed from both sides when the central shield
Photo 2: Clean the area where the control unit is to be installed with a cloth (D).
Photo 3: Remove the film from the two-sided adhesive tape and fix the control unit in place by pressing
down on the mouth of the siren for at least 15/20 sec. (E). Turn the alarm wiring downwards (F).
Photo 4: Route the wiring and fix it with the plastic clamps as shown in photo 4 ref. (G).
Wire up the two alarm connectors, i.e. the four-pole connector and one-pole connector (H). Proceed by
disconnecting the 13-pin connector of the left-hand commutator and insert the two connectors of the
alarm wiring (I).
Photo 5: Fix the LED under the handlebar in the central zone using two-sided adhesive tape (L) and press
down for at least 15/20 sec. Make the electrical connections with the two-way connector. Fasten the Led
wire as shown in photo 5 ref. (M).
Two-sided adhesive tape is provided in the Kit and can be used to fix the LED's plastic support.
In this case, the tape must be cut to size and applied to the bottom of the LED without
Re-assemble the previously removed plastic parts on both sides of the scooter.
5
Fitting Instructions
NOTE
the original adhesive.
NOTE
are in the front part, under the instrument panel.
CAUTION
is disassembled, see photo ref. (C)
NOTE
removing the original adhesive
State of the art. 10/2006
SUZUKI GENUINE ACCESSORIES
EN