Suzuki 990D0-05H00-ALM Manual Del Usuario página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

STEP-BY-STEP FITTING GUIDE - BURGMAN 125_200
The vehicle's original electrical system is pre-engineered for connecting the alarm system.
The two connectors (one-pole connector and four-pole connector, closed with counterpart)
Photo A: Clean the base of the alarm control unit and apply the larger piece of double-sided adhesive
tape supplied in the kit (1).
Connect the connector of the alarm wiring to the control unit, fit the rubber cap into the relative housing
and fix it in place with the plastic clamp (2). Turn the antenna and fix it into the slot in the control unit
(3) with the clamp.
Definition of the connectors; (4) Pre-engineering for the Alarm, (5) Turn indicators, (6) LED.
Adapt the alarm wiring to suit the dimensions shown in the picture (A). Use tape or a clamp to join the
two branches of the wiring to connector (4) and (5). The distance between connector (5) and connector
(4) must be 160 mm.
Photo 1: Remove the portion of fairing from above the headlight (A) by unscrewing the two screws near
the rear view mirrors and extracting the central pin from between the two headlights. Disassemble the
main fairing by unscrewing the screws from around the perimeter of the vehicle. Lift up the two foot mats
and remove the screws and plastic clips until you reach halfway along the central tunnel. There are other
screws and clips to remove in the internal front area alongside the radiator (B).
Photo 2: Clean the zone where the control unit is to be installed, remove the film from the two-sided
adhesive tape and fix the control unit in place by pressing down on the mouth of the siren for at least
15/20 sec. (C).
Route the wiring and fix it in place with the plastic clamps (D).
Proceed by disconnecting the 13-pin connector of the left-hand commutator and insert the two connectors
of the alarm wiring (E).
Fix the wiring in place with the plastic clamps, (F, G).
Photo 3: Wire up the two alarm connectors under the instrument panel, i.e. the four-pole connector and
the one-pole connector, (H).
Route the wire of the LED connector and fix it in place with the clamp (I).
After having positioned the LED, wire it to the two-way connector (L).
Photo 4: Position the LED as shown in photo (M).
Two-sided adhesive tape is provided in the Kit and can be used to fix the LED's plastic support.
In this case, the tape must be cut to size and applied to the bottom of the LED without removing
Re-assemble the previously removed plastic parts on both sides of the scooter
HOW TO ENABLE THE ALARM SYSTEM
Enabling the alarm system
To activate the Alarm system, turn the ignition key OFF-ON-OFF after which the Alarm System's Led will
flash the same number of times as the number of transmitters memorized (two will have been memorized
by the factory). This process activates the system. Consult the user manual provided with Alarm Kit code
990D0 – ALARM – 000 for the functional specifications.
6
Fitting Instructions
NOTE
are in the front part, under the instrument panel.
NOTE
the original adhesive
State of the art. 04/2006
SUZUKI GENUINE ACCESSORIES
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido