Superwinch SAC1000 Manual Del Propietário página 7

G E N E R A L S A F E T Y
I N F O R M A T I O N
( C O N T. )
19. DO NOT USE THE WINCH TO
HOLD LOADS IN PLACE. Use
other means of securing loads
such as tie down straps.
Superwinch offers a wide variety
of tie downs. Contact your local
Superwinch dealer.
20. USE ONLY FACTORY APPROVED
SWITCHES, REMOTE CONTROLS
AND ACCESSORIES. Use of non-
factory approved components
may cause injury or property
damage and could void your
warranty.
21. DO NOT MACHINE OR WELD
ANY PART OF THE WINCH. Such
alterations may weaken the
structural integrity of the winch
and could void your warranty.
get very hot (Figure 7).
22. Never allow shock loads to be
applied to winch or wire rope.
23. Use caution when pulling or
lowering a load up and down a
ramp or incline. Keep people,
pets and property clear of the
path of the load.
24. Do not power the winch out for
more than 50 feet (15.2m) or
longer than 2 minutes.
HOT!
Figure 7
The drum and
wire rope may
M O U N T I N G
Y O U R W I N C H
mounted with the wire rope in the
underwind direction. Improper
mounting could damage your winch
and void your warranty.
This unit may be mounted in either
a horizontal or vertical position, on
a wall or other suitable support. In
all installations, the unit must be
mounted so that the wire rope
feeds perpendicular to the drum
axis and does not rub across the
housing or base.
6.0
(152)
1.24
(31.5)
5.9
(150) 3.69
(93.7)
3.1
(79)
7.1
(180)
NOTES
1. All dimensions are in inches [millimeters].
2. Winch is mounted with M10 x 1.5 hardware. Typical
mount is to flat surface capable of handling the loads.
Bolts to be ISO Grade 8.8 or better.
This winch
MUST be
11.1
(282)
12.5
(317)
5.2
(132)
7