Handle Installation - Kohler K-110 Instrucciones De Instalación

3. SHOWERHEAD CONNECTION - ALL INSTALLATIONS
Thread the female end of the shower hose onto the nipple
(Section B).
Connect the opposite end of the shower hose (Section A)
to the showerhead assembly.
NOTE: Only the deck-mount installation is shown.
Showerhead connection is identical for all installations.

4. HANDLE INSTALLATION

IN EACH INSTALLATION MAKE SURE THE VALVES ARE IN THE CLOSED POSITION.
FOLLOW ONLY THE STEPS THAT APPLY TO YOUR HANDLE STYLE.
INSTALL ANTIQUE OVAL HANDLES
Insert the stem screw into the stem extension, and tighten
with a Phillips screwdriver.
Position the ceramic insert onto the handle, and connect
with the handle screw.
CAUTION: Risk of product damage. Do not
overtighten. Overtightening may cause damage to
handle.
Loosen the setscrew, and position the handle assembly on
the stem extension. Remove the handle, and rotate it one
spline clockwise or counterclockwise to achieve an even,
horizontal position.
NOTE: For fine adjustment, pull out the stem extension
until it disengages from the valve, rotate, and return the
stem extension to its original position. Do not pull the
stem extension out completely.
Tighten the setscrew.
Repeat this procedure for the other handle.
Run hot and cold water through the faucet and hand
shower to remove any debris. Check for leaks.
Kohler Co.
Deck-Mount Installation Is Shown
Stem
Screw
Bonnet
Stem
Extension
Handle
Screw
HOT
Open
Close
Shown In Closed Position
6
A
Showerhead
Assembly
Nipple
B
Shower
Hose
Fig. #15
Setscrew
Oval
Handle
Ceramic
Insert
COLD
Open
Close
Fig. #16
1008209-2-
D