Kohler K-110 Instrucciones De Instalación página 8

INSTALL IV GEORGES HANDLES
CAUTION: Risk of product damage. Do not
overtighten. Overtightening may cause damage to
the handle or hardware.
Position the stem extension onto the valve stem. Thread
the bonnet to the valve body.
With the valve turned off, align the bath adapter over the
stem extension so the holes line up horizontally. Secure
with the screw. Assemble the skirt cap onto the end of the
bath adapter.
Position the long sleeve over the handle arm. Fit the
O-ring onto the handle arm. Insert the handle arm
through the bath adapter, as shown. Set the short sleeve
over the handle arm, and thread it onto the end cap.
NOTE: For fine adjustment, pull out the stem extension
until it disengages from the valve, rotate, and return the
stem extension to its original position. Do not pull the
stem extension out completely.
Repeat for the other handle.
Run hot and cold water through the faucet and hand
shower to remove any debris. Check for leaks.
CALL US FOR HELP
Questions? Problems? First review the installation instructions to ensure correct installation. For additional
assistance, call our Customer Service Department for direct help. You may also contact us at our web site listed
below.
Kohler Co.
Stem
Extension
Open
Close
In the U.S.A., call 1-800-4-KOHLER
In Canada, call 1-800-964-5590
In Mexico, call 001-877-680-1310
kohler.com
8
End Cap
Short
Sleeve
Washer
Bonnet
O-Ring
Bath
Adapter
Long Sleeve
Handle Arm
HOT COLD
Shown In Closed Position
Fig. #19
Screw
Skirt Cap
Open
Close
D
1008209-2-