Descargar Imprimir esta página

Assembly Anker; What You Need - Extremis ANKER Instrucciones De Montaje

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34

ASSEMBLY ANKER

WHAT YOU NEED

2 people
no. 17 spanner
no. 5 hex key
+/- 30 min.
2. Place the assembled legs in a triangle with the leg tubes facing inwards as shown on the diagram above.
3. Position the bench between the table legs and then affix it to the legs with 2 M10x25 carriage bolts, 2 M10 lock
washers and two M10 nuts but do not fully tighten them yet. Do the same thing for all the benches.
4
assembly anker + assembly floor fastening
1. Lay the leg support on its side on the floor (use the packaging to protect
it) and affix the leg tube using 2 M8x25 countersunk bolts. Do the same
thing for each leg.
Optional floor fastening
Fit the optional anchor plate with the tab facing upwards (as shown in
the picture above). Do the same for each leg.
Optionele grondverankering

Publicidad

Capítulos

loading