Assembly Extempore Bench Extra High; What You Need - Extremis EXTEMPORE Manual De Instrucciones

ASSEMBLY EXTEMPORE BENCH EXTRA HIGH

WHAT YOU NEED

2 people
no. 13 spanner
no. 4 hex key
+/- 15 min.
2. Insert the 4 assembly rods in the holes provided to that
end in the corner elements. Tighten the rods by means
of the 4 bolts using a no. 13 key. Do not tighten the
bolts too much as this could cause them to break.
4. Put the inox tube in the holes of the 2 remaining legs.
4 assembly extempore bank extra high + table extra high
1. Put the bench on the ground upside down (the wooden
surface should face the ground). Use the packing
material to protect the surface.
3. Place a leg, without a hole in it, over the stainless steel
rod. Tighten the screws M8x25 and repeat this action for
the other corner on the same long side.
5. Place the legs over the inox rods and fix them by
tightning the screws. The bench is now ready. Turn it
upside down.