Graco 8486 Manual Del Usuario página 16

To Install Locking Clip:
1. Tighten the buckled
belt by pushing down
hard on the car seat
and pulling hard on the
shoulder belt.
2. While pushing down
on seat, pinch the two
Ê
straps together behind
the buckle tongue.
Unbuckle the belt without
½ " (1.25 cm)
allowing it to slip.
3. Connect lap and
shoulder belts as
Ê
shown .
4. Rebuckle belt. Check
that lap belt does not
move by pulling hard. If
belt loosens or lengthens,
repeat procedure.
Remove locking clip when
not using car seat. Store
under it's tab on the back
of seat.
16