Cequent Towing Products 75563 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75563F
Wrenches: ¾, 19mm
Drill Bits: None
Note: Fasteners typical
both sides
1
Qty. (2) Hex bolt ½-13 x 1.75 GR5
2
Qty. (4) ½ Conical Toothed Washer
1. Raise hitch into position and align the slots of the receiver with the weldnuts in the frame rail.
2. Install the M12 X 1.25 X 40mm bolts and conical toothed washer through the hitch and into the weldnuts.
3. Insert the handle nuts through the large hole in the vehicle frame rail as shown above.
4. Install the ½-13 X 1.75 bolts and conical toothed washers.
Tighten all M12 X 1.25 CL 10.9 fasteners with torque wrench to 115 Lb.-Ft. (156 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2007 Cequent Towing Products
Installation Instructions
Fascia
Frame Rail
4
2
1
2
3
Tighten all 1/2-13 GR 5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Acura RDX
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1, SUV2
3
Qty. (2)
4
Qty. (2)
Sheet 1 of 3
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
Not For Use With Spring Bars
4000 (1816 Kg)
M12 X 1.25 X 40mm CL 10.9
½ Handle Nut
75563N 7-27-07
Part Numbers:
75563
87449
44584
Max Tongue
WT (LB)
400 (182 Kg)
Existing Weldnut
– Both Sides
Rev. A
Form: F205 Rev A 5-6-05