Cequent Towing Products 75561 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75561F
Wrenches: 13mm, 14mm, 17mm
Drill Bits: None
1
Qty. (4) M10 X 1.25 X 40mm CL 8.8
1. Lower exhaust by removing two (2) rubber exhaust hangers on the driver's side of the vehicle and one (1) on the passenger's
side of the vehicle.
2. Remove tow hook bracket (see figure 2) by removing five (5) M10 bolts and return to vehicle owner.
3. Raise hitch into position and install four (4) M10 X 1.25 X 40mm bolts and conical toothed washers provided with hitch, two (2)
per side.
4. Tighten all fasteners to the required torque specification.
5. Raise exhaust back into position and re-install rubber isolators
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2007 Cequent Towing Products
Installation Instructions
Hyundai Tucson
Kia Sportage
Fascia
Frame Rail
Existing Weldnuts
Fasteners Typical Both Sides
Tighten all M10 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Bumper
Structure
2
1
2
Qty. (4) 3/8 Conical Toothed Washer
Sheet 1 of 3 75561N
Part Numbers:
Max Gross
Trailer WT (LB)
Not For Use With Spring Bars
3500 (1589 Kg) 350 (159 Kg)
Wiring Access Location:
KIA Sportage 4 Cyl. Models – SUV1,2
KIA Sportage 6 Cyl. Models – SUV5
HYUNDAI TUCSON – SUV1,2
Figure 2
7-18-07
75561
87447
44582
Max Tongue
WT (LB)
Rev. A