Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
`
Always wear SAFETY GLASSES
when installing hitch
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
1.
Scrape frame rails to remove any undercoating.
2.
Run the M12 bolts into existing weldnuts in frame rail to remove any debris. Remove bolts.
3.
Raise hitch into position, aligning slots in hitch side brackets with existing weldnuts in vehicle frame rail. Install M12 bolts and
conical toothed washers as shown. Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2015 Cequent™ Performance Products, Inc. -
Installation Instructions
PART NUMBERS: 75952, 87679, 44761
Fastener Kit: 75852F
Wiring Access Location: SUV3, 4
Figure 1
Rear
Printed in Mexico
①
②
Existing
weld nuts
Frame rail
②
①
Sheet 3 of 12
75952NP
Qty.(5)
Bolt
M12x1.25x40 CL10.9
Qty. (5)
Conical Tooth
Washer ½"
Teeth side
against hitch
1-22-15
Rev. A
Publicidad
Tabla de contenido
