Cequent Performance Products 76028 Instrucciones De Instalación página 5

5. On vehicles without existing weldnuts in the
bumper: Pull carriage bolts and small blocks
thru end of the bumper and feed through the
bumper mounting bracket using the pull wire.
Attach conical washer and nut. As shown
Figure 1.
On vehicle with existing weldnuts in
bumper: Install the M12 bolts and conical
washer through the bumper mounting bracket
into the existing
weld nuts in the bumper, as shown Figure 2.
7. Replace the fascia door on the 2005-2015 Equinox. For 2016 and newer see
Figure 4 for optional trimming. (Obtain owners permission prior to trimming).
For all other models return fascia door to owner.
Note: Due to different configuration of the vehicle there will be extra hardware
left over.
©2016 Cequent™ Performance Products, Inc. -
6. Tighten all 1/2-13 GR5 fastener with torque wrench to 75 Lb.-Ft. (102 N*M). Tighten all M12
CL10.9 fasteners with torque wrench to 92 Lb.-Ft. (125 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Printed in Mexico
Sheet 5 of 15 76028NP 3-30-16 Rev. A