Publicidad
Idiomas disponibles
Idiomas disponibles
Assemble the CYLINDER (79) to the Cylinder caddy. See detail 9-A.
Place the CYLINDER RETAINER WIRE (77) over the Cylinder Collar. See detail 9-B.
Step
Attaching TYPE 1 fitting to the fuel outlet valve in detail 9-C
9
Outlet
Valve
Engineering Code
LD113342 * /LD113322 *
LE113342 * /LE113322 *
LE113343*
*Cylinder not included
9-A Set CYLINDER (79) in the cylinder caddy with
the outlet valve facing the front of the grill.
IMPORTANT!
T
O ENSURE PROPER GAS FLOW
"OFF"
CONTROL VALVES MUST BE
OPENING THE GAS CYLINDER VALVE
9-B
9-A
79
9-B Place the CYLINDER RETAINER WIRE (77)
over the Cylinder collar, by rotating the wire
from the original position toward the cylinder
collar.
WARNING:
grill and when attaching or replacing the
L.P. gas cylinder, insure that the gas
supply hose is free of kinks and/or
,
damage and is at least 3" away from hot
BURNER
BEFORE
surfaces such as the grill casting.
.
77
Left end
9-C Insert the TYPE 1 nipple of the regulator (27)
During assembly of
77
Outlet
Valve
TYPE 1
Nipple
27
79
into the cylinder's fuel valve outlet as shown.
Turn the regulator hand wheel clockwise to
tighten. No tools are needed. The Hand
wheel will come to a complete stop when the
connection is secure and gas will not flow until
a positive seal is achieved.
11412013FX (Pg. 11)
9-C
Publicidad
