Connecting The Unit To A Pioneer Plasma Television (See Chapter 8); Connecting The Unit To Other Televisions (See Chapter 9) - Pioneer PDA-V100HD Manual De Instrucciones

Using the unit
Operation modes
Independent 2 mode

Connecting the unit to a Pioneer plasma television (see Chapter 8)

Operations, indicators, conditions, and precautions when connecting the unit to a Pioneer plasma television are as
follows:
* See the section Features (page 7) regarding the model numbers of supported Pioneer plasma televisions.
Operations • The plasma television's remote control can be used to control the unit's input selector.
• The unit's power switch is linked to that of the plasma television; when the plasma television's power
switch is set to off, this unit's power is also automatically turned off.
Indicators The HDMI CONTROL indicator lights green.
Conditions • The HDMI CONTROL switch must be set to ON.
• The plasma television's "HDMI Control Setting" menu must be set to allow control of this unit.
Note: For setting details, consult the Operating Instructions for your plasma television.
Precautions • The INPUT button and the remote control's INPUT (1 to 6) buttons cannot be used to change the
unit's input selection.
• The input selection for the component connected to INPUT 6 connector cannot be changed.
• If the HDMI CONTROL switch is set from ON to OFF, be sure also to cancel the plasma television's
"HDMI Control Setting".

Connecting the unit to other televisions (see Chapter 9)

Operations, indicators, conditions, and precautions when using the unit as an AV selector are as follows:
Operations • The INPUT button and remote control's INPUT (1 to 6) buttons can be used to change the unit's input
selection.
Indicators The HDMI CONTROL indicators do not light.
Conditions • The HDMI CONTROL switch must be set to OFF.
Precautions • The plasma television's remote control cannot be used to control the unit's input selector.
Operations/Operation restrictions
Operations:
• HDMI Control function is not used.
• The unit does not operate in linkage to other components,
but as an independent component.
• The INPUT button on PDA-V100HD and its remote control
unit can be used to switch the unit's corresponding
INPUT 1 to INPUT 6.
HDMI Control setting
Settings required on this unit:
HDMI CONTROL switch: OFF
07
15
En