Advanced Functions; Connecting Control Cables - Pioneer PDA-V100HD Manual De Instrucciones

10

Advanced functions

Chapter 10
Advanced functions

Connecting control cables

Connect control cables between the unit and other
Pioneer equipment having the
operate the connected equipment by sending
commands from its remote control unit to the remote
control sensor on the unit.
After the CONTROL IN/OUT terminals have been
connected, the remote control sensors on the
connected equipment do not accept commands from
the remote control units. Face the remote control units
to the remote control sensors on the unit when
operating the connected equipment.
Note
• Make sure that the power is turned off when making
connections.
• Complete all component connections before
making control cable connections.
18
En
logo. You can then
The control cables (commercially available) are mono
sound cables with mini plugs (no resistance).
OUT
I N
SERVICE ONLY
CONTROL
Y
COMPONENT
VIDEO
P B
HDMI L L
R R
P
AUDIO R AUDIO
OUTPUT INPUT 1 INPUT 3 INPUT 4 INPUT 6 INPUT 1 INPUT 2
HDMI compliant
cable
Plasma television
Note
• When connecting the control connector, be sure to
simultaneously connect analog audio cables or
video cables. System control will not operate
properly when digital connections alone are made.
• When using SR connections to a Pioneer plasma
television, point the unit's remote control at the
plasma television's signal sensor when operating.
S-VIDEO VIDEO
R-AUDIO-L
INPUT 5
L
ON/OFF
R
AC IN
AUDIO
HDMI
CONTROL INPUT 3 INPUT 4
Rear view
I N OUT
CONTROL
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT