Pioneer PDA-V100HD Manual De Instrucciones página 29

Additional information
Independent 2 mode
Power ON
Condition
indicator
Power ON Lights blue
Power ON
(setting mode)
STANDBY Off
During setting mode
For about five seconds after pressing the remote control unit buttons to enter a setting mode, the indicators will
appear as noted below:
When the setting mode ends, the unit will return to power ON mode for ordinary operation.
(*) Factory default settings
When setting HDMI output resolution (when RESOLUTION button is pressed.)
Item
Auto (*) 1 2
480p/576p 1 2
720p 1 2
1080i 1 2
When setting colour system for analog signals (when COLOUR SYSTEM button is pressed.)
Item
Auto (*) 1 2
PAL 1 2
SECAM 1 2
NTSC 1 2
4.43 NTSC 1 2
PAL 60 1 2
STANDBY HDMI CONTROL
indicator indicators
Off
Lights red
INPUT indicators
3 4 5 6
3 4 5 6
3 4 5 6
3 4 5 6
INPUT indicators
3 4 5 6
3 4 5 6
3 4 5 6
3 4 5 6
3 4 5 6
3 4 5 6
INPUT indicators
All off Only currently selected
input lights
Depends on relevant
settings
All off
Blue illumination
Flashes blue • When power ON.
• When currently selected input is INPUT 2,
INPUT 3*, or INPUT 5.
* When setting the type of component
connected to SCART connector.
Blue illumination
Flashes blue • When power ON.
• When currently selected input is INPUT 3*,
INPUT 5.
* When setting the type of component
connected to SCART connector.
Blue
Remarks
illumination
Lights blue
Flashes blue (See chart "During
setting mode")
Off
Indicator status
Indicator status
12
29
En