Pioneer PDA-V100HD Manual De Instrucciones página 25

Additional information
Problem
Sound is distorted.
Video images from analog
inputs are not displayed
properly.
Video is distorted.
Can't make settings
Remote control unit doesn't
respond.
Remote control unit doesn't
respond (SR connection)
Remote control unit doesn't
respond (PDP combination
mode)
Power ON indicator flashes
blue
Even after making settings
with the remote control unit,
the corresponding indicators
don't light.
Possible solution
• Replace connection cable.
• Confirm that the input component is set correctly.
• If distortion occurs in the input component's video signal (like when performing fast
forward), depending on the video quality, some distortion may appear, or the image
may cease to appear properly.
The same symptoms may also appear depending on the performance of the television.
Also check the following settings on this unit:
• Is the colour system set properly? (See page 19.)
• If INPUT 3 is selected, is the input signal set correctly? (See page 19.)
• Is the colour format set correctly? (See page 20.)
• See the section Changing settings on page 19.
• Check remote control unit's batteries; if depleted, replace with new. (See page 12.)
• If too distant from the receiver, move closer. (See page 13.)
• If an obstacle is located between the remote control unit and the signal receiver,
remove the obstacle. (See page 13.)
• If a bright fluorescent lamp or other light is shining on the remote signal sensor,
remove the light fixture farther away. (See page 13.)
• When using SR connections, point this unit's remote control at the signal sensor on
the plasma television to operate. When SR connections are not used, operate this
unit's remote control while pointing it at the signal sensor on PDA-V100HD itself. (See
page 18.)
• The remote control unit will not operate when a control cable is connected to the
CONTROL IN connector. Confirm that a control cable has not been inserted to the
CONTROL IN connector. (See page 18.)
• Confirm that the connector is not connected to the connector of another
manufacturer's component having the same function. (See page 18.)
• During PDP combination mode (HDMI CONTROL indicator lights green), INPUT (1
to 6) buttons on this unit's remote control are not supported. This is not a malfunction.
• When not using PDP combination mode (HDMI CONTROL indicator lights orange or
doesn't light), the plasma television's remote control unit cannot be used for
controlling operations.
• Try disconnecting the power cord from its power outlet then reconnecting it (do not
repeat this numerous times). If the symptom persists, consult your Pioneer dealer or
service station.
• Are you attempting to make settings that are not supported?
Perform only those settings that are supported. (See page 19.)
12
25
En