Speaker Connection; Remote Control Unit; Battery Installation - Teac AG-H600NT Manual Del Usuario

Speaker Connection

Right Speaker
Caution
< Check the impedance of your speakers. Connect speaker with an
impedance of between 4 ohms and 8 ohms.
< The red speaker terminals are + (positive) and the black speaker
terminals are _ (negative).
Generally, the + side of the speaker cable is marked to make
it distinguishable from the _ side of the cable. Connect the
marked side to the + terminal and the unmarked side to the
black _ terminal.
< The metal portions of the two separate wires should not touch
or an electrical short can occur. Shorted wires can create a fire
hazard or induce a failure in your equipment.
< Be sure to insert each plug securely. To prevent hum and noise,
avoid bundling the cables together with the AC power cord or
other cables.
How to connect:
1. Turn the terminal cap counterclockwise to loosen it. The speaker
terminal caps cannot be fully removed from the base.
2. Insert the wire into the terminal and turn the terminal cap
clockwise to securely connect it:
< Make sure none of the wire insulation is under the terminal and
only the bare, stripped wire is touching the terminal.
3. Make sure the cable is fastened firmly by pulling the cable lightly.
AG-H600NT/AG-H600DNT
Left Speaker

Remote Control Unit

You can operate the unit using the remote control unit RC-1181
supplied with it.
When operating the remote control unit, point it towards the
remote sensor on the front panel of the unit.
< Remote control operation may be impossible if there are any
obstacles between the unit and the remote control.
< If the remote control unit is operated near other appliances which
generate infrared rays, or if other remote control devices using
infrared rays are used near the unit, it may operate incorrectly.
And conversely, the other appliances may operate incorrectly.

Battery Installation

1. Remove the battery compartment cover.
2. Insert two "AAA" (R03, UM-4) dry batteries. Make sure that the
batteries are inserted with their positive "+" and negative "_"
poles positioned correctly.
3. Close the cover.
Battery Replacement
If the effective range decreases, the batteries are exhausted. In
this case replace the batteries with new ones.
Precautions concerning batteries
< Be sure to insert the batteries with correct positive "+" and
negative "_" polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable and non-rechargeable batteries can be used. Refer
to the precautions on their labels.
< When the remote control unit is not to be used for a long time
(more than a month), remove the batteries from the battery
compartment to prevent them from leaking. If they leak, wipe
away the liquid inside the battery compartment and replace the
batteries with new ones.
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
9