Listening To Fm/Am - Teac AG-H600NT Manual Del Usuario

1
1 Select FM or AM by pressing the SOURCE button repeatedly.
< You can also use the BAND button on the remote control unit.
2 Select the desired tuning mode.
Each time the TUNING MODE button is pressed, the tuning mode
changes as follows:
Manual tune
FM
< >
Auto tune
FM
< >
A
Preset tune
FM
CH01

Listening to FM/AM

2
3
108.00MHz
108.00MHz
108.00MHz
3 Select the station you want to listen to.
Manual tuning mode
Turn the MULTI JOG/ENTER knob (or press the TUNING/PRESET
‡/° button on the remote control unit) until the station you
want to listen to is found.
The frequency changes by a fixed step (FM: 50 kHz steps, AM: 9
kHz steps).
Auto tuning mode
Turn the MULTI JOG/ENTER knob (or press the TUNING/PRESET
‡/° button on the remote control unit) to begin auto
tuning.
When a station is found, the unit tunes in the station
automatically. Repeat this step until the station you want to
listen to is found.
< Press the TUNING MODE button to stop the auto tuning.
FM Mode
Pressing the FM MODE button alternates between Stereo mode
and Mono mode.
Stereo:
FM stereo broadcasts are received in stereo and the stereo
indicator is displayed.
FM ¤S
< >
Mono:
Select this mode when the signal is weak. Reception will be
forced monaural, reducing unwanted noise.
108.00MHz
21