Product Operation; Battery Charging - Amibot Flex Manual Del Usuario

Product Operation

Battery Charging

1. Charging station placement
Place charging station against the wall and
Remove obstacles from within 1 meter at two sides
and about 2 meters in front of the station, as shown
in the right figure.
2. If the robot has been shut down, power on the robot by pressing the power switch at the right side of
the robot for more than 3 seconds.
3. Charge the robot in either way as shown below:
a. Insert the adaptor into the robot and the plug at the other end to power socket as shown in Fig a.
b. Press
recharging as shown in Fig b.
Note:
a. Make sure robot is turned on during charging. Otherwise, it will show ERROR on its display.
b. When robot is being charged, LED panel will gradually show 11:11, from left to right.
c. Once charging is complete, LED panel will show FULL.
d. During working, the robot will return to charging station automatically when battery power is low and
LED panel will show
For extending battery life:
a. Before first use, charge the robot for 12 hours.
b. Charge the robot as soon as battery power is low.
on robot or remote control to operate the robot to go back to charging station for
.
10