Assembling The Shelves; Combining The Frames And The Shelves; Combining Sets Of Flower Steps - Gardenline 94228 Manual Del Usuario

Assembling the flower steps

Assembling the shelves

1. Lay out one shelf
2. Align the screw holes.
3. Loosely fasten the ornamental fringe to the shelf with three M6 × 12 mm
(see Fig. D).
screws 7
4. Check the position of the ornamental fringe on the shelf. If it is satisfactory,
tighten the M6 × 12 mm screws with either the open-ended spanner
the ring spanner
The shelf is now assembled (see Fig. E).
Repeat for the remaining ornamental fringes and shelves.
Next, combine the frames and shelves (see chapter "Combining the frames
and the shelves").

Combining the frames and the shelves

1. Make sure one shelf
2. Turn the assembled frames upside down and place the topmost part of the
hook frames
Make sure the holes in the hook frames align with the holes on the shelf.
3. Loosely attach the shelf to the hook frames by manually inserting and
securing four M6 × 25 mm screws
Repeat for the remaining shelves.
4. Carefully turn the loosely-assembled flower steps upright.
5. Check the positioning of all components is satisfactory.
6. Tighten all the screws with either the open-ended spanner
spanner 13
7. Carefully move the flower steps to the desired location.
8. Re-check that the M6 × 12 mm screws
M6 × 30 mm screws
The flower steps are now ready for use (see Fig. G).

Combining sets of flower steps

You can combine several sets of flower steps to form a series of flower steps.
1. Position the sets of flower steps next to each other.
2. Locate the plastic stoppers
2
frames that are next to each other in the individual sets of flower steps
(see Fig. H).
3. Remove the plastic stoppers. You may need to use a flat-headed
screwdriver (not included).
4. Align the holes in both sets of flower steps.
5. Manually insert M6 × 38 mm screws
12
3 and an ornamental fringe
13
.
3 is upside down.
1 on the shelf.
.
9
are still securely tightened.
14
(see Fig. F).
8
7
, the M6 × 25 mm screws, and the
in the hook frames
10 into the aligned holes.
5 .
12 or the ring
1 and the short L
12 or