Switching The Appliance On And Off - J.P. SELECTA TUV NORD COMBATEMP S Manual De Instalación

INSTRUCTION MANUAL CODE 80079 REV F
Operating and control elements
ON/OFF button (to switch the appliance on and off)
1
Selection buttons
2
Set button (Enter)
3
Audible warning on/off button
4
Button for calling up stored alarm events
5
Temperature display
6
Control elements
Compressor is running
LED flashing - refrigeration unit switches on after a delay. The
compressor will start automatically after the pressure in the
refrigerant circuit has equalised. )
Temperature display via product sensor is activated
AUX
Alarm function
If appears in the display, the appliance has a fault. Consult
your nearest customer service point.
(Hazard Analysis Critical Control Point)
HACCP
The HACCP display means that the power supply and
interior temperature of the appliance are recorded.
If HACCP flashes in the display, there has either been a
power failure or the temperature in the appliance exceeded
the permissible range.

Switching the appliance on and off

Connect the appliance to the mains - the display reads OFF.
Switching the appliance on: Keep the ON/OFF button
pressed for approx. 5 seconds - the display reads ON.
No alarm is displayed or sounded when the appliance is switched
on for the first time.
If the appliance is disconnected from the mains for a long time after
it has been switched on for the first time and if the temperature
inside the appliance rises above the upper alarm limit, this will
be detected as a fault by the electronic control system (HACCP
appears in the display).
When the appliance is switched on again, this display must be
reset as shown below.
Press button .
Press + for 5 seconds. The display will read
The HACCP LED will now light up permanently.
Press for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
Switching the appliance off: Keep the ON/OFF button
pressed for approx. 5 seconds - the display reads OFF.
J
.P. SELECTA s.a.u.
Jun/2018
6.2 Models 2101181 and 2101182 (-40ºC)
.
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.jpselecta.es
(It can be modified without notice)
Setting the temperature
• Press button for 1 second. The temperature display flashes.
• To increase the temperature (warmer): press button
• To reduce the temperature (colder): press button
• Press button again.
The desired temperature setting is saved.
Audible warning signal
The audible warning signal will sound in certain alarm events.
It can be cancelled by pressing button
Lid open alarm
When the lid is opened, the LED
display begins to flash.
When the lid has been left open for more than 60 seconds, the
LED begins to flash, and
flash alternately in the display.
The audible warning signal sounds (unless the audible warning
signal function has been deactivated).
If the lid has to stay open for longer in order to insert items to be
cooled, cancel the audible warning signal by pressing button
If the lid is open, the audible warning
signal can also be muted by pressing
the contact switch on the electronics
housing. This will disable the audible
warning signal for 60 seconds.
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
Page: 17
.
.
.
lights up and the temperature
and the temperature indication
GB
.
17