J.P. SELECTA TUV NORD COMBATEMP S Manual De Instalación página 20

MANUAL DE INSTRUCCIONES CODIGO 80079 REV F
Calling up stored alarm events and reading
the temperature progression
Display =
Scroll through the list using
Number of temperature alarms
Last temperature alarm
Last temperature alarm but one
Temperature alarm before
Number of power cuts
Last power cut
Last power cut but one
Power cut before
Period in hours in which the maximum and minimum interior
temperatures were measured
Maximum (highest) measured temperature
Lowest measured temperature
Select the required item using the
again to return to the list.
Note: You can exit the menu at any time by pressing
seconds.
If no button is pressed within 60 seconds, the electronic control
system switches back automatically.
Resetting the recorded temperature progres-
sion
Complete the following steps if you wish to reset the value saved
for in the previous section to 0.
Display =
Press the button or
Display = -
Press for 5 seconds. Display =
The values for and
temperature) are then reset to the current interior temperature.
Press for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
20
J
.P. SELECTA s.a.u.
or .
button. Press this button
until appears in the display.
.
(highest and lowest measured interior
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.jpselecta.es
Jun/2018 (Sujetas a modificaciones sin previo aviso)
Example of an alarm query
Situation: HA/HF/HACCP flashes in the display.
Display =
Display =
Display =
Press this button until
Display =
Display =
Display =
Display =
Display =
Display =
for 5
Display =
Display =
Display =
Press + for 5 seconds. The display will read
The HACCP LED will now light up permanently.
HA/HF is cancelled in the display.
The electronic control system is now ready for the next alarm.
Press for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
There has not been an alarm status with
a too high or too low temperature. You
must switch to display
appears in the display.
1 power failure has occurred.
Last power failure.
Year 2014
Month 05 (May)
Day 30
Hour 23
Minute 14
The power failure lasted 3 hours.
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
Pag.: 20
.
.