J.P. SELECTA TUV NORD COMBATEMP S Manual De Instalación página 22

MANUAL DE INSTRUCCIONES CODIGO 80079 REV F
Changing the network address
When connecting several appliances via the RS485 interface,
each appliance must have its own network address.
Press for 5 seconds. Display =
Display =
Display =
Display =
Display =
Use buttons or to change the network address
Display =
Press for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
Resetting the parameters to factory settings
The alarm limits and sensor calibration values can be reset
to the factory settings using this function.
Pull out the mains plug.
Keep pressed and connect the mains plug.
Display =
Display =
The electronic control system will automatically switch back to
normal operating mode.
22
J
.P. SELECTA s.a.u.
Jun/2018
( )
- .
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.jpselecta.es
(Sujetas a modificaciones sin previo aviso)
Setting the real time clock
The real time clock is preset (CET). Other time zones or summer/
winter time must be adjusted manually.
Press for 5 seconds. Display =
Display =
Display =
Display = Set the year by pressing the
buttons.
= save new setting
Display =
Display = Set the month by pressing the
buttons.
= save new setting
Display = Day (1-31)
Display = Set the day by pressing the
= save new setting
Display = Days of the week (1 = Monday,
7 = Sunday)
Display = Set the day of the week by pressing the
= save new setting
Display =
Display = Set the hour by pressing the
buttons.
= save new setting
Display =
Display = Set the minutes by pressing the
buttons.
= save new setting
Press for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
Note
When appears in the display, the real time clock must
be reset.
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
Pag.: 22
Year 2014
Month (1-12)
buttons.
buttons.
Hour (0-23)
Minute (0-59)