Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION MANUAL CODE 80079 REV F
Calibrating the control sensor
temperature control)
Possible tolerances of the control sensor (the displayed tempera-
ture compared to the actual interior temperature) can be offset
with this function.
Press
for 5 seconds. Display =
Display =
Display =
Display = correction value set at the factory
Use buttons
or
to increase or decrease the correction
value in 0.1°C increments.
Display = actual (corrected) interior temperature
Display =
Press
for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
Product sensor
(available accessory)
The temperature may be measured or recorded at any point in
the interior using the product sensor.
• Connect sensor (see section entitled External alarm)
Activating the sensor
Press
for 5 seconds. Display =
Display =
Display =
Display =
Display =
Press
for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
If
appears in the display, the product sensor has not
been activated.
If
appears in the display, the product sensor has not been
connected, or is faulty.
J
.P. SELECTA s.a.u.
Jun/2018
(standard sensor for
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.jpselecta.es
(It can be modified without notice)
Calibrating the product sensor
Possible tolerances of the product sensor (the set temperature
compared to the actual interior temperature) can be offset with
this function.
Press
for 5 seconds. Display =
Display =
Display =
Display =
.
Display =
Use buttons
or
to increase or decrease the correction
value in 0.1°C increments.
Display = actual (corrected) product sensor temperature
Press
for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
Switching the temperature display between
control sensor and product sensor
Press
for 5 seconds. Display =
Display =
(control sensor)
Display =
(product sensor)
If the product sensor is activated,
AUX appears in the display.
Display =
Press
for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
Page: 21
GB
21
Publicidad
Tabla de contenido
