PEERLESS PARAMOUNT PRTLU Guia De Instalacion página 8

Mounting and Removing Flat Panel Screen
3
Tension Adjustment of Ratchet Handle:
handle. NOTE: If obstruction prevents ratchet handle from rotating, pull handle out while turning will
allow handle to reposition without tightening. Release and turn handle to tighten or loosen.
Mounting Screen: Ratchet handle must be in the up or down position or interference will occur while
hooking tilt brackets to wall plate (A). Slowly hook tilt brackets (B & C) onto wall plate (A) and swing
screen down as shown in fig. 3.1. Tilt bracket hooks must fully engage wall plate as shown in detail 1.
Always use an assistant to safely lift and position the flat panel screen. Using a phillips screw driver, turn
safety screws on tilt brackets (B & C) clockwise till screw tip securely contacts wall plate as shown in cross
section.
Removing Screen: To remove screen from mount, loosen safety screws, swing screen away from
mount, and lift screen off of mount.
B & C
B & C
WARNING
Failure to lock brackets (B & C) with safety
screws can cause sceen to come off mount
if hit accidentally.
Adjust tension in tilt brackets (B & C) by rotating ratchet
A
DETAIL 1
A
SAFETY
SCREW
CROSS SECTION
RATCHET
HANDLE
8 of 32
fig 3.1
ISSUED: 11-03-09 SHEET #: 202-9395-1