PEERLESS PARAMOUNT PRTLU Guia De Instalacion página 9

Screen Adjustment: Screen can be adjusted horizontally by loosening safety screws on tilt
3-1
brackets (B & C) three full turns with a phillips screw driver. Adjust screen as shown in figure
3.2. Tighten safety screws on tilt brackets till screw tip securely contacts wall plate as shown
in cross section.
Adjusting the Tilt Angle of the Flat Panel Screen
4
For preset tilt angles use
INCRELOK™: The screen can be locked into a pre-set tilt position of -5°, 0°, 5°,
locator hole to find tilt position hole and tilt screen to align holes. Tighten IncreLok™ tilt locking
screws on both tilt brackets to lock tilt as shown in detail 2.
Ratchet Handle: Loosen ratchet handle (refer to step 3 for tension adjustment of handle).
pull from top or bottom of screen to adjust tilt as shown in figure 4.1. The tilt can be adjusted to a
maximum of 15° forward or 5° backward.
POSITION
HOLES
Increlok™ and for custom tilt angle use ratchet handle.
IncreLok™ TILT
LOCKING SCREW
TILT
DETAIL 2
fig. 3.2
LOCATOR
HOLE
RATCHET
HANDLE
9 of 32
10° or 15°. Use
fig 4.1
ISSUED: 11-03-09 SHEET #: 202-9395-1
Push or