Back to Basics L5754A Manual De Instrucciones página 3

Please check all packaging material carefully before discarding. Many
accessory parts are contained within the packaging material.
Before assembling your meat grinder wash all parts, except the motor base in
warm, soapy water, rinse thoroughly and dry. To prolong the life of your meat
grinder, do not wash parts in the dishwasher.
Sausage
Tubes
Cutting
Plates
Screw Cap
Grinding Meat:
1. Place the head tightly into the motor base opening. Holding the head with one
hand, place the locking knob in the hole on the side of the motor base and
tighten by turning it clockwise.
2. Place the feed screw into the head; long end first, by turning the feed screw
slightly until it is set into the motor base.
3. Place the cutting blade onto the feed screw shaft with the flat side facing in.
B U
EFORE SING FOR THE
Food Pusher
Cutting
Feed
Blade
Screw
U Y
SING OUR
F
IRST
Head
Tube Collar
M G
EAT RINDER
3
T
IME
Hopper Plate
Reverse
"ON/OFF"
Locking
Knob
Sausage
Switch
Switch