Multifan V-FloFan Instrucciones De Instalación - Instrucciones De Uso página 5

V-FloFan
A max 5m for best results
B ± 18m for best results
Obstacles
A
B
C
Illustration 5: V-FloFan obstacle free area
A >0,5m
B >0,5m
C >2m
It is very important that there are no obstacles within the indicated area.
Obstacles within this area will disrupt the airflow and may cause the fan to
vibrate.
Suspension
The fan must be suspended from a rigid structure. In greenhouses, the fan
should preferably be suspended directly from the truss of the greenhouse. A
special bracket kit is available as an optional accessory. This bracket kit will fit
the most commonly used greenhouse trusses. Contact your supplier for more
information.
Illustration 6: V-FloFan optional bracket for greenhouses
INS00008-B Original instructions
A
Illustration 7: V-FloFan suspension examples
A in a greenhouse with the special truss bracket
B lowered from the ridge of a building using a profile
Always observe the following:
• The fan must be suspended from a rigid structure.
• If the fan cannot be suspended directly from e.g. a truss or purlin, use ri-
C
gid angle iron or tubular profiles to suspend the fan.
WARNING
The profile must be rigid enough so that it will not flex in any
direction. This will prevent resonance as a result of the forces
generated by the fan.
WARNING
Do not suspend the fan using chains, rope, steel cable or sim-
ilar.
The V-FloFan will spin and/or sway.
Guarding
This fan is default supplied with a guard at the bottom (intake) side. This fan is
intended to be installed at such a height where a guard at the top (exhaust)
side is usually not required.
NOTICE
The fan must be guarded according to local regulations
Condensate drain holes
The fan motor has drain holes to allow condensation that may form inside the
motor to leave the motor. After installation, the drain hole at the lowest point
of the motor must be open, the other drain holes must be closed.
Spare condensate drain plugs are supplied with the fan. Keep all the drain
plugs as they must be temporarily reinserted in the open drain holes during
wet cleaning.
Illustration 8: Condensate drain plug
B
ENGLISH | 5