Publicidad
Step 12
NOTE: Be sure to position the BOTTOM (L) exactly as shown.
å
Fasten the BOTTOM (L) to the RIGHT END (A). Tighten two
å
TWIST-LOCK® FASTENERS.
Fasten the BOTTOM (L) to the BACKS (I and J) and LARGE
å
UPRIGHT (M). Use six BLACK 1-15/16" FLAT HEAD SCREWS (113S)
through the exact holes shown in the BOTTOM.
NOTE: You should start each SCREW a few turns before
å
completely tightening any of them.
BLACK 1-15/16" FLAT HEAD SCREW
(6 used in this step)
Page 16
113S
L
M
I
421982
Part (L). Another
sturdier, easier,
friendlier component!
A
J
www.sauder.com/services
Publicidad
