Replacing The Plug Fuse (12/24 V); Defrosting The Cooler - Dometic GROUP WAECO CoolMatic FC40 Instrucciones De Uso

Operation
6.7

Replacing the plug fuse (12/24 V)

➤ Pull the adapter sleeve (fig. 3 4, page 3) off of the plug.
➤ Unscrew the screw (fig. 3 5, page 3) out of the upper half of the housing
(fig. 3 1, page 3).
➤ Carefully raise the upper half of the housing from the lower (fig. 3 6,
page 3) half.
➤ Take out the contact pin (fig. 3 3, page 3).
➤ Replace the defective fuse (fig. 3 2, page 3) with a new one that has the
same rating (8A 32V).
➤ Re-assemble the plug in the reverse order.
6.8

Defrosting the cooler

Humidity can form frost in the interior of the cooling device or on the evapo-
rator. This reduces the cooling capacity. Defrost the device in good time to
avoid this.
A
NOTICE! Danger of damage!
Never use hard or pointed tools to remove ice or to loosen objects
which have frozen in place.
To defrost the cooler, proceed as follows:
➤ Take out the contents of the cooling device.
➤ If necessary, place them in another cooling device to keep them cool.
➤ Switch off the device.
➤ Leave the lid open.
➤ Wipe off the defrosted water.
28
Autogoods "130"
CoolMatic FC40
EN