SATA 96411 Manual Del Uso página 12

96411 / 96412
Lock the wrench by holding the handle with one hand and turning the lock ring
4
counterclockwise to the end.
Example of torque setting
To set the torque to 104 Nm. First pull down the lock ring and turn the handle until the vertical scale reading on the rod shows
"100" while the " 0 " position of horizontal scale is equal to the centerline of scale. Then continue to rotate the handle clockwise
until the mark " 4 " coincides with the centerline of scale. The torque value at this time is 100+4=104 N.m.
- 03 -
12
EN DE RU KO PT JA ES