Change Of Set Points; Setpoint Editing From Display; Setpoint Editing From Bms; Change Language - Daikin UATYA-BBAY1 Manual De Operación

2.3 Change of set points

2.3.1

Setpoint editing from display

Go to the main menu and press "Setpoint" to access the screens where functions are displayed whose setpoints
need to be managed.
Go to the "Setpoint" sub menu and select the function whose setpoint is to be changed.
Scroll the parameters until the desired parameter setpoint is achieved.
Select the setpoint parameter to enable the edit keypad.
Set the new value and apply the green tick to confirm.
Units featuring mode switching have a setpoint for cooling "ST7" and a setpoint for heating "STH7".
The setpoint for cooling "ST7" must necessarily be higher than the setpoint for heating "STH7".
If values that do not meet this condition are set by mistake, the controller activates alarm "AL183".
Alarm "AL183" is displayed for warning purposes only.
2.3.2

Setpoint editing from BMS

Setpoints can be edited from the BMS only if this function is enabled.
See dedicated BMS management document.

2.4 Change language

When in the main menu, press "Languages" to access the screens in which the available languages are displayed.
If the language you are looking for is not in the screen, use the arrows to find it.
The selected language becomes active as soon as it is selected.
We reserve the right to make changes without any prior notice.
UATYA
4P645203-1
Translation from original instructions
Packaged Rooftop
7