Skymsen MAXICONV VP Manual De Instrucciones página 23

PROBLEM
- The oven doesn´t turn on.
- Motor doesn´t spin
- Oven causing shocks
- Protection breaker unframed - Breaker not well dimensioned
- Oven heating excessivily
- Steam doesn´t work
- The oven takes too long to
bake.
- Uneven Baking
- Products with odor
TABLE 02
CAUSES
- Lack of phase
- Turned off breaker
- Unregulated or open door
- Lack of Phase
- The fan is stuck in the
protection grid or in the vapor
tube
- Unregulated or open door
- Irregular grounding
- Poor ventilation of the room
- Lack of water in the hydraulic
net
- Low pressure of the hydraulic
net
- There is water but it doesn´t
flow to the camera
- Very low temperature
- Dirty cooking camera
- Excessive loading
- Very low temperature
- Dirty cooking camera
- Uneven oven
- Excessive loading
- Dirty cooking camera
SOLUTIONS
- Check
- Check
- Readjust the door and
stopper until the end.
- Check
- Make the components´
repositioning
- Readjust the door and
stopper until the end
- Check
- Check the nominal power
of the oven and measure the
breaker again.
- Check ventilation system
- Check
- Check
- Obstructed steam tube,
execute cleaning or the
repositioning of the item.
- The temperature is not
adequate, readjust;
- Execute cleaning
- Verify the loading capacity of
the appliance
- Not appropriate time and
temperature, readjust
- Clean it
- Even the appliance
- Verify the loading capacity of
the appliance
- Execute cleaning
23