Warnings And Error Messages - Husqvarna HTC D60 Manual De Usuario

HTC D60

9.1 Warnings and error messages

Warnings
Warnings appear on a yellow background at the top of the screen. A warning does not usually stop
operation but the machine may have restricted functionality. Actions to ensure operation may need to
be taken. A warning can normally be minimized using the OK key and the warning is then minimized
to an icon in the icon field. When the problem has been solved, the warning disappears.
Error Message
5V POWER PROBLEM
Duratiq Rmt no resp
PTC Short Circuit
USB/PTC Overcurrent
PSens Err 000
29
Circuit board internal voltage error.
DURATIQ Remote Connection internal error.
Overload on USB or PTC. Short-circuit?
Pressure sensor error.
Causes automatic pulsing to only work on time and not on filter status/
flow. Some display values also stop working, see below.
Each pressure sensor error has a three digit error code, each sensor has
its own place in the three digit code that indicates which sensor is faulty.
Sensor diff error
1xx The values of the sensors do not correspond.
May be due to defective sensor or one of the following errors.
Error in pressure sensor P_in (pressure sensor in coarse filter con-
tainer)
x#x
Error in pressure sensor P_in means filter status does not work.
Automatic pulsing only occurs on time.
Error in pressure sensor P_tot (Pressure sensor after fine filter)
Error in pressure sensor P_tot means flow meter, negative pressure
xx#
meter and filter status do not work. Automatic pulsing only occurs
on time.
Error code Designation
SENSOR
1 SHORT TO
GND
SENSOR
2
SHORT TO REF
SENSOR LIMIT
4
HIGH
SENSOR LIMIT
8
LOW
Example:
Error code 4 on sensor P_in and error 1 on pressure sensor P_tot, the error
message will be: PSens Err 041
Description
Short-circuit in PTC circuit
Internal error on circuit board/sensor
Internal error on circuit board/sensor
The sensor gives a value that is greater
than what is normal/possible. Pressure
sensor error.
The sensor gives a value that is less than
what is considered normal.
May be due to leakage in the dust bag,
filter, seals,
pressure sensor hose etc. for example.
May also be due to a defective sensor.
Description
V 1.0