Error Message - Husqvarna HTC D60 Manual De Usuario

Error Message

Error messages appear on a red background at the top of the screen. An error usually stops one or
more functions of the machine. Action may need to be taken to resume operation.
Error Message
Motor Overload
Terminal xx
Overload
Pump Direction
Ctrl Failure
V 1.0
Description
The overcurrent protection has
tripped.
Resets automatically when the
machine has cooled
Short circuit on terminals 1-12.
After three failed start-up at-
tempts three alternatives are
displayed.
The machine struggles to read
the phase sequence.
Cause
May be due to suction system stoppage
(high negative pressure).
Low voltage.
Excessive heat.
Defective motor.
xx indicates to which terminal the short
circuit applies.
Alternativ
Is the
p u m p
direction
correct?
HTC D60
Yes
No
Try Again
30