Philips WP3870 Manual Del Usuario página 45

2
3
1
4222.002.6965.3.indd 45
13 Place the filter holder with filter into the wall holder.
14 Push down the filter holder release lever to lock the filter holder
into place ('click').
15 Place the water reservoir onto the wall holder. Put the cover on the
water reservoir. Make sure that the water reservoir tap is closed.
16 Open the main water valve. Observe the water purifier for 5
minutes to check for any leakage between connections.
17 If leakage occurs, repeat all previous steps in this chapter.
18 The water reservoir now automatically fills with purified water to its
maximum volume of approximately 4 liters. An internal mechanism
prevents the reservoir from overflowing.
19 After the reservoir has filled up to its maximum volume for the first
time, remove the reservoir cover and add 30ml of household bleach
(5% solution of sodium hypochlorite). If your household bleach
contains a solution of only 2.5% sodium hypochlorite, you should use
60ml. Mix the bleach thoroughly through the water with a spoon.
This disinfects the inside of the water reservoir. After 1 minute drain
the reservoir and throw away the water. After the reservoir has
filled up again to its maximum volume, check if the water still has
a chlorine taste. If it does, throw away the second full reservoir of
water as well.
The water purifier is now ready for use.
English
45
26-02-09 08:23