Maytag MBL1957VES Guia Del Usuario página 19

PROBLEM POSSIBLE CAUSES
Refrigerator is leaking Plastic tubing was used to complete water
water connection.
Ice forms in inlet tube to Improper water valve was installed.
ice maker
Water pressure is low.
Water flow is slower than Freezer temperature is too high.
normal
Water pressure is low.
Improper water valve was installed.
Water droplets form on Check gaskets for proper seal.
outside of refrigerator
Humidity levels are high.
Controls require adjustment.
Water droplets form on Humidity levels are high or door has been
inside of refrigerator been opened frequently.
Check gaskets for proper seal.
WHAT TO DO
Use copper tubing for installation. Plastic is less durable and
can cause leakage.
Check water connection procedure in the Installation
Instructions. Self-piercing and 3/16" saddle valves cause low
water pressure and may clog the line over time.
Water pressure must be between 20 to 100 pounds per square
inch to function properly.
See page 7. Freezer temperature should be approximately
0° F (-18° C).
Water pressure must be between 20 to 100 pounds per square
inch to function properly.
Check water connection procedure in the Installation
Instructions. Self-piercing and 3/16" saddle valves cause low
water pressure and may clog the line over time.
Clean, if necessary. See page 14.
Normal during times of high humidity.
See page 7.
Minimize door openings.
Clean, if necessary. See page 14.
18