Maintenance And Servicing, Elimination Of Faults; Working On The Electrical Equipment; Working On The Hydraulic Equipment - Parker EOMAT ECO Manual De Funcionamiento

EOMAT ECO
2.3. Maintenance and servicing, elimination of faults (see chapter 14)
Carry out on a regular basis the adjustments, servicing and maintenance stipulated. After
completing any maintenance work and before switching on again, check the functionality
of the safety equipment..

2.4. Working on the electrical equipment

• All work on the machine's electrical equipment should be carried out in principle only
by properly qualified skilled electrician personnel.
• If problems with the electrical supply occur, the installation should be switched off im-
mediately.
• Before starting any work on parts of the installation which are provided with electrical
power, the installation should be disconnected from the supply and secured against
unexpected reconnection.
• The installation's electrical equipment must be checked regularly. Defects such as, for
example, cable damage, loose connections, etc. should be reported immediately and
made good.
• All personnel not authorised to carry out work on the system's electrical supply must
be barred from access to the interior of the control cabinet.

2.5. Working on the hydraulic equipment

The machine works with the help of hydraulic pressure power. When dealing with hydrau-
lic power, there are definite special safety measures to be observed.
All work on the machine's hydraulic equipment must in principle be carried out only
•
by properly qualified skilled staff.
Any system sections or pressure circuits to be opened must be switched to zero
•
pressure before repair work commences.
Fluids escaping under high pressure can penetrate the
skin and cause severe injury.
In case of injury by pressurised fluids, call a doctor
immediately. There is a danger of infection!
Page 12 EOMATECO/MANUAL