Parker EOMAT ECO Manual De Funcionamiento página 34

EOMAT ECO
17 Potential faults and their elimination
Fault
The machine slides when the
tube is inserted
Oil leaking
Cylinder does not travel forward
Leakage after fitting assembly
Possible causes
The machine is standing on a
slippery base
Oil refill plug not closed
Too little oil in hydraulics
Assembly cone worn
Page 33
Recommended measures
Stand the machine on a non-slip
base. When dealing with large
tubes, stand the machine in front
of a firm edge, so that it cannot
slide away to the back.
Always close oil refill plug during
transportation.
Check oil level and replenish if
necessary
Always keep assembly cones
clean and lubricate them.
Check assembly cones regularly
in accordance with the operating
manual.
Always keep the Operating
Manual in mind.
EOMATECO/MANUAL