Functional Description; Removing/Inserting The Battery - Milwaukee M18 SWITCH TANK 2820-20 Manual Del Operador

FUNCTIONAL DESCRIPTION

1. Tank
2. Tank cap
3. Wand storage location
4. Carry handle
5. Spray wand
6. Trigger lock-on ^
7. Trigger handle ^
8. Trigger lock-off ^
9. Shoulder straps
10. Hose
2
1
Cat. No.
49-16-28PS
49-16-28CS
19
20
18
17
21
16
22
23
25
28
24
11. Tank hook receptacle
12. Waist strap
13. Adjustable nozzle ^
14. Nozzle holder
15. Battery compartment
16. Battery compartment latch
17. Tank latch
18. Flow rate dial
19. On/Off switch
20. On/Off light
21. Water nozzle *
22. Adjustable nozzle ^
23. Fan nozzle ^
24. Strainer
25. Tank hooks
26. Gallon markings
27. Liter markings
28. Measuring cup ¤
* 49-16-28WS only
^ 49-16-28PS and 49-16-28CS only
7
6
5
4
3
15
Cat. No.
49-16-28WS
¤ 49-16-28PS only
Cat. No. ..................................................... 2820-20
Volts.............................................................. 18 DC
8 Battery Type .................................................M18™
Charger Type................................................M18™
Tank Capacity ..................................... 4 Gal. (15 L)
Flow Rate ................................... 0.10 to 1.13 GPM
Full Weight .....................................................55 lbs
Recommended Ambient
Operating Temperature ....................32°F to 125°F
9
Tank Only (Pesticide)........................... 49-16-28PS
Tank Only (Concrete)........................... 49-16-28CS
Tank Only (Water) ............................... 49-16-28WS
10
WARNING
3
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

11
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
12
WARNING
may be hazardous.
13
Connecting the Spray Wand
14
(Cat. No. 49-16-28PS, 49-16-28CS)
1. Insert the spray wand into the trigger
26
handle (1) until firmly seated.
2. Slide the nut onto the threaded cou-
pling and hand tighten securely (2).
3. Pull on the spray wand to be certain
27
it is properly secured.
4. Place the assembled trigger handle
and wand into one of the wand storage
locations.
(Cat. No. 49-16-28PS, 49-16-28CS)
Select and screw on nozzle by job type. When using
the adjustable nozzle, adjust spray pattern as desired
by tightening/loosening the nozzle.
Connecting Water Supply or Nozzle
To attach water supply hose to the tool or
nozzle, push the quick connect fitting and
tool/nozzle together (1). Pull on the con-
nection to be certain it is properly secured.
To remove, pull the collar back to release
(2). When using the nozzle, adjust spray
pattern as desired by tightening/loosen-
ing the nozzle.
4
SPECIFICATIONS
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove battery pack before
changing or removing accessories.
Only use accessories specifically
recommended for this tool. Others
to the Trigger Handle
Connecting the Nozzles
(Cat. No. 49-16-28WS)
2
1
1
2