Height Adjustment; Options - Castors; Options - Castor Position - Breezy Style X Manual Del Usuario

Option Elevating Legrest
(Fig. 13.0-15.0)
To remove, pull the lever (1), swing
the footplate outwards and then lift
the legrest out.

Height Adjustment:

The lower leg length can be
adjusted infinitely by releasing the
screw (2). Adjust the suitable height
and tighten the screw again.
CAUTION!
The distance between the foot-
plate and the ground must be at
least 40 mm.
Angle Adjustment:
Press the lever (3) downward with
one hand while supporting the
legrest with the other hand to take
the load off. When a suitable angle
is achieved, let go of the lever and
the legrest will lock into one of the
preset positions.
3
CAUTION!
• Keep hands clear of the adjustment mechanism between, the
frame and the movable parts of the footrest while elevating or
lowering the footrest.
• The footrests should not be used to lift or to carry the wheelchair.
• Risk of trapping fingers!
• When moving the footrest up or down, do not put your fingers in
the adjusting mechanism between the moving parts of the
footrest.
Adjusting the calf pad
The calf pad can be adjusted as follows:
Height: Open bolt (4 Fig.16.0) and
move the clamping piece to the
desired position. By rotating the
clamping piece also the angle can
be adjusted.
Depth: Open bolt (5) and move the
calf pad into the desired position.
Width: Open bolt (5) and position
the spacers (6) behind the pad, to
get the desired position.
CAUTION!
Always make sure that the fasteners are secure.
Amputee Support
(Fig.17).
The Amputee Support can be
adjusted in every direction as
required.
16 BREEZY STYLE X / BREEZY STYLE X ULTRA
Fig. 13.0
1
Fig. 14.0
2
Fig. 15.0
Fig.16.0
5
4
6
Fig.17.0

Options - Castors

Castors, castor plates, forks
The wheelchair may veer slightly to the right or left, or the castors
may wobble. This may be caused by the following:
• Forward and/or reverse wheel motion has not been set properly.
• The castor angle has not been set correctly.
• Castor and/or rear wheel air pressure is incorrect; the wheels do
not turn smoothly.
The wheelchair will not move in a straight line if the castors have not
been properly adjusted. Castors should always be adjusted by an
authorised dealer. The castor plates must be re-adjusted, and the
wheel locks must be checked every time the rear wheel position has
been altered.
The seat height is determined by the castor and rear wheel position.
The seat height can be adjusted by altering the position of the rear
wheels and the castors (see seat height matrix on page 14).
CAUTION!
After adjusting the seat height, all screws must be re-tightened and
the wheel lock must be readjusted.

Options - Castor Position

Items description
1. Tooth Washer 2. Castor
5. Washer 6. Screw
Fig. A
Select the tooth washer adjustment position & Hand.(LH/RH)
A1-side A (pos.1 ,Pos.2)
A2-side B (pos.3 ,Pos.4)
Note 1:(see provider configuration table, to choose the
adjustment position for the seat height)
SIDE A
LEFT HAND
A1
TOOTH WASHER LEFT HAND (LH)
3. Plastic Ring 4. Castor Adaptor
7. Allen Key
1
Fig. A
SIDE B
LEFT HAND