Installing Power Strips - Sun Microsystems 806-2997-10 Guia De Instalacion

Installing Power Strips

Power strip B is mounted forward of power strip A, and so must be installed first.
FIGURE 1-4
1. If you have not already done so, reinstall the power strip mounting bracket and
the power strip mounting bracket cover.
2. Connect cable B to the connector on the bottom of power strip B.
Five notches on the socket side of the connector line up with five keys on the
plug side of the connector to ensure proper alignment. The master (large) key on
the power strip is on the power strip bracket side of the connector.
Alternately, you may attach the connector after the power strip is installed.
3. Holding the top of the power strip away from the rack, insert the tab on the
bottom of the power strip into the slot on the bottom of the power strip mounting
bracket.
4. Slide the tab on the top of the power strip into the slot on the top of the power
strip mounting bracket. Tighten the securing screw at the top of the power strip
mounting bracket.
5. Repeat Step 2 through Step 4 for power strip A.
6. Apply the provided labels "A" and "B" to their respective power strips.
1-6 Power Distribution System Installation Guide • November 2002
Installing a Power Strip