How To Use; Getting Started; Filling The Water Tank - Black+Decker ICL500 Manual De Uso Y Cuidado

HOW TO U SE
This product is for household use only.
G E T T ING STARTE D
• Remove all labels, tags and stickers attached to the body, cord, or
soleplate of the iron and the plastic band around the power plug.
• Remove and save literature.

FILLING THE WATER TANK

1. Remove iron from the base. Take the iron far enough
from the base so that water won't spill onto the base
when filling tank.
2. With the soleplate tilted at a 45° angle, open the
water-fill cover. (A)
3. Using a clean measuring cup, pour water slowly into opening until
water reaches the "MAX" level mark on the side of the water tank.
Do not overfill. Close the water-fill cover securely.
Tip: You may use the iron with tap water. If your water is hard you
should use distilled water (not chemically descaled or softened water).
Do not use water with perfumes or scented additives.
HEATING YOUR IRON
Your iron is heated by placing it onto the stand. The smart status light will
show you when you need to reheat your iron and when it is ready to use.
The smart status light operates as follows:
Smart Status Light
Steady red
Flashing green
Flashing red
Flashing red, 3 beeps Recharge needed
Slowly pulsing red
Important Note:
Between ironing tasks always put the iron back onto the base. This ensures
the most efficient heating and gives you the best performance from your iron.
1. Plug the base into an outlet.
2 Place the iron onto the base to preheat and to recharge as
needed. Smart status light will be a steady red.
3. Follow fabric care instructions on garments to determine the
appropriate temperature setting.
Heating up
Ready to use
Recharge warning
Auto shut-off activated
5
Iron mode
A